Grey Goose Vodka Vase

I was asked to cut down a Grey Goose vodka bottle to help replace a broken one from a set someone had. greygooseI wasn’t mad keen, as I’ve been really focused on the¬†copper-foil designs with my spare time, but I agreed out of curiosity of what the bottles were like as a one-off favour. I’d seen these bottles used a lot for bottle cutting state-side, but not had one to try before. ¬†There’s not a lot of range of where to cut due the nature of the etched design, with around 15mm window of flat bottle just above the goose’s head. I decided to give the Kinkajou cutter a go on this one, and the cut went ok, but on water fracturing there was a tiny run showing, which had to be flatted out quite deeply with the pads. This is where the lack if space hinders a second lower cut to get a perfect flat. The end result was still pretty good in the end though, though I have done better. It was interesting to try, and the etched finish stood up to the process, though I was very careful to avoid scratching and rubs.

Leave a Reply

Your email address will not be published. Required fields are marked *